Milk Jug Rinser Bench Top Long Drain Tray

$543.29

Rinsing steaming pitchers between each use is not only a sanitary preparation practice, but is also beneficial to the proper production of quality textured milk. The Pitcher Rinser can be configured into virtually any application. Rectangle in shape, with built-in water and drain connections; also plumbed for drainage. Adaptable to most any espresso bar. Comes with easy to follow installation instructions.

Prices incl. GST

Out of stock

Categories: , SKU: 32510

Description

Threaded connections are half inch and push fitting is 3/8″

Pitchers should be rinsed using cold water. Cold water cools the pitcher and brings the temperature down from the food danger zone. Hot or warm water will rinse the pitcher, but will not bring the pitcher temperature down.

610mm x 175mm x 25mm

Milk Jug Rinser Bench Top Long Drain Tray Installation Tips:

A 350kpa PLV is recommended for all installations. . This is to alleviate the possibility of the valve weeping or leaking under the higher pressure and to reduce the possibility of the seal being blown up over the feed holes and restricting the water flow.

We recommend flushing the feed water lines to the rinser before installation especially on new water lines, this is to prevent any debris getting in to the valve and holding the seal of the seat and causing the valve to leak.

Reviews

There are no reviews yet.

Be the first to review “Milk Jug Rinser Bench Top Long Drain Tray”

Your email address will not be published. Required fields are marked *

Post comment

Related products